Home>Blog > Neuspeed Torque Arm Insert - 22.10.92
Published on 2019-01-21

Neuspeed Torque Arm Insert - 22.10.92

Fits 2014-up Audi A3(8V) / 2015-UP VW MK7 GTI & Golf

Parts List:

  • 1 - Urethane Insert
  • 1 - Stainless Steel Cup Washer

Tools Required:

  • 1 – 21mm Socket
  • 1 – Silicone Spray
  • 1 – Torque Wrench
  • 1 – Jack
  • 1 – Jack Stands

1. Raise front of vehicle and support with jack stands under lifting points. NEVER WORK UNDER A VEHICLE SUPPORTED ONLY WITH A JACK!

Unbolt and remove the 21mm hex bolt from torque mount in sub-frame.

2. Unbolt and remove the 21mm hex bolt from torque mount in sub-frame.

Use Silicone spray on urethane insert to ease installation, match up to rubber mount and push up until fully seated.

3. Use Silicone spray on urethane insert to ease installation, match up to rubber mount and push up until fully seated.

Install factory bolt through SS Cup Washer and tighten into mount.

4. Install factory bolt through SS Cup Washer and tighten into mount.

Torque bolt to 100Nm (74 ft/lbs) + 1/4 turn.

5. Torque bolt to 100Nm (74 ft/lbs) + 1/4 turn.